Bosch AVENAR 8000 - Day and Night Mode

FPA-5000 | FPA-1200 | AVENAR panel 8000 |
AVENAR panel 2000 | AVENAR keypad 8000
Alarm | en 35
Bosch Sicherheitssysteme GmbH
User Guide
2022-01 | 5.0 | F.01U.378.877
8 Alarm
i
Notice!
Information on how to handle a fire alarm can be found in Fire alarm, page 41 .
This chapter contains information about the following points:
– Types of alarm, page 35
– Entry delays, page 35
– Day and night mode, page 36
– Alarm message to the panel, page 37
Refer to the Fire alarm chapter for the following topics:
– Acknowledging a message, page 42
– Silence internal buzzer, page 42
– Activate and silence signaling devices, page 42
– Resetting signaling devices and transmission devices, page 42
– Triggering fire verification, page 43
– Resetting alarm message, page 44
– Bypassing detectors, page 45
i
Notice!
Depending on the configuration, the manner in which alarm displays are shown and handled
in this guide may differ from the guide on the system.
8.1 Types of alarm
On the panel controller, a distinction is made between the following types of alarm:
– Fire
– Heat
– Smoke
– Water
– Supervisory
Depending on the configuration, external transmission devices (e.g. fire department),
notification appliances (e.g. sirens and/or strobes) and fire protection systems (e.g. sprinkler
systems, fire doors) are activated.
i
Notice!
If an alarm delay is set for the detector triggering the alarm, the alarm signal is not
transmitted immediately and the message can be checked; see Entry delays.
8.2 Entry delays
To prevent false alarms, it is possible to delay the transmission of the first alarm signal. The
transmission device to the fire department is not activated immediately in this case. During
the delay, the message can be checked to ensure it is correct.
The FSP-5000-RPS programming software can be used to program various strategies for
avoiding false alarms. These strategies are principally used in fire detectors but can also be
assigned to any other detector, depending on how it is configured.
The alarm delays that can be shown in the panel controller display are explained below.