Bosch AVENAR 8000 - Maintenance - Walktest; Walktest Groups; Adding or Deleting Elements

FPA-5000 | FPA-1200 | AVENAR panel 8000 |
AVENAR panel 2000 | AVENAR keypad 8000
Maintenance | en 65
Bosch Sicherheitssysteme GmbH
User Guide
2022-01 | 5.0 | F.01U.378.877
14 Maintenance
This chapter contains information about the following points:
– Walktest: see Maintenance – walktest, page 67
– Change language, page 65
– Activate Outputs, page 65
– Activate Transmission Device, page 66
– Detector removal
– History Log: see Maintenance – history log, page 71
– Bypassing/Un-bypassing buzzer, page 66
14.1 Menu overview
Maintenance -> Walktest Change language
Activate outputs Activate transmission device
History log Bypass buzzer
14.2 Change language
i
Notice!
The fastest way to change the language display is via a shortcut; see also Changing language
display, page 29 .
There are two ways of selecting a different language display:
– Using the menu
– Entering a shortcut; see Changing language display, page 29 .
i
Notice!
After the system starts up following a power cut or battery failure, the default language
defined in the FSP-5000-RPS programming software is set again.
Making a selection via the menu
1. In the start menu, select Maintenance
2. Change language
A list of the languages which can be selected is displayed.
3. Select the language you require.
The displays are displayed in the selected language.
14.3 Activate Outputs
1. In the start menu, select Maintenance
2. Activate outputs
Various element categories are displayed.
3. Select a category or Select by number and enter the number of the element into the
search screen; see also Search Function/Element, page 27
4. Select the required list fields. The list fields are marked.
5. Select On to activate the selected notification appliances.
The selected signaling devices are activated.
6. Select All to activate all notification appliances.
7. To end activation of the selected elements, repeat the same steps but select Off in step
5.