FPA-5000 | FPA-1200 | AVENAR panel 8000 |
AVENAR panel 2000 | AVENAR keypad 8000
Maintenance – walktest | en 67
Bosch Sicherheitssysteme GmbH User Guide 2020-07 | 3.0 | F.01U.378.877
In order to add new elements:
1. Select New.
The display changes. Various element categories containing elements which have not
been assigned to any walktest group yet are displayed.
2. Select the element category you require.
3. Select one or more list fields.
The list fields are marked.
4. Select Add.
The selected element is added to the selected walktest group.
Change name
To change the name of the input or output group:
1. Overwrite the name; see
Entering numbers and text, page 27
.
2. Select OK.
The new name is confirmed.
15.2 Starting and ending walktest
Notice!
The information about the date and time of every walktest is stored in the history log. You can
print this information on a printer. See
Maintenance – history log, page 69
.
15.2.1 Starting the walktest
To select the elements for the walktest and to switch them to walktest:
1. In the start menu, select Maintenance
2. Walktest
3. Start / End walktest
Various element categories are displayed.
4. Select:
– More... to display further categories or
– one of the displayed categories or
– Select by number and enter the number of the element into the search screen; see
also
Search Function/Element, page 26
.
Notice!
If you select the element category Loop, Logical zone, Detector or Walktest group, you will
be asked to select the type of walk test. Select Sequential walktest to check each individual
sensor (optical, chemical or thermal) of the detectors you are testing, or select Simultaneous
walktest to test combination detectors using a test device with combined trigger substances
for simultaneous testing of multiple sensors.
Example:
1. Select Walktest group.
2. Select Sequential walktest or Simultaneous walktest
A list of walktest groups is displayed. Refer to
Scrolling through lists, page 25
for
information on how to navigate through a list.
3. Select the list field you require.
The field is marked.
4. Select On.
The selected walktest group is switched to walktest.
To Next Page
Loading...
Need help?
General
