58 en | Diagnostics
FPA-5000 | FPA-1200 | AVENAR panel 8000 |
AVENAR panel 2000 | AVENAR keypad 8000
2022-01 | 5.0 | F.01U.378.877
User Guide
Bosch Sicherheitssysteme GmbH
3. Select Yes.
A list of various data types is displayed.
4. Select the field you require.
The field is marked.
The data of each selected element is requested.
5. Select Start.
To cancel the operation, select Cancel.
A status bar appears.
6. Select the arrow keys to display further information.
7. Select Refresh to update data if necessary.
13.3 Modules
To display diagnostic information about a particular module:
1. In the start menu, select Diagnostics
2. Modules
Two different lists are offered.
3. Select a list, e.g. By number. Refer to chapter Scrolling through lists for information on
how to scroll through a list.
A list of all used modules is displayed.
4. Select the list field you require.
A list of various information options is displayed:
– Module passport
– Module Compatibility
– Module status
For an LSN module, the following selection fields are also offered:
– Module status and counters
– Reset counters
5. Select the information option you require, e.g. Module status.
Diagnostic information about the module status is displayed.
A status bar appears.
6. Select the arrow keys to display further information.
7. Select Refresh to update data if necessary.
13.4 Hardware
13.4.1 LED test
To test the LEDs in the LED display:
1. In the start menu, select Diagnostics.
2. Select Hardware.
3. Select LED test.
For the duration of approximately five seconds, all LEDs on the LED display light up.
13.4.2 Display test
To test the operativeness of the display:
1. In the start menu, select Diagnostics.
2. Select Hardware.
3. Select Display test. These are the results:
– The buzzer and all indicators on the panel controller and functional modules are switched
on for a short time.
– A part of the display is sequentially filled with the colors white, black, red, green and
blue.
To Next Page
Loading...
