FPA-5000 | FPA-1200 | AVENAR panel 8000 |
AVENAR panel 2000 | AVENAR keypad 8000
Diagnostics | en 57
Bosch Sicherheitssysteme GmbH
User Guide
2022-01 | 5.0 | F.01U.378.877
13 Diagnostics
This chapter contains information about the following points:
–
Element details, page 57
: Diagnostic information about an LSN module and about
elements of a selected LSN module
–
Modules, page 58
: Diagnostic information (software version) and hardware diagnostic
data about modules
–
Hardware, page 58
: Information about released addresses, statistical data for the
transmission, and the execution of display tests
–
Panel Passport, page 59
: Diagnostic information about the panel controller
–
LED Test on modules, page 59
: Testing the LED display of modules
–
Network services, page 59
: Information on the availability of other nodes within the
system network
–
Voice alarm systems (VAS), page 62
: Diagnostic information about a connected voice
alarm system (VAS)
13.1 Menu overview
Diagnostics -> Element details Modules
Hardware Panel passport
LED test on modules History log
Network services VAS
13.2 Element details
To display diagnostic information about the elements in a particular module:
1. In the start menu, select Diagnostics
2. Element details
A list of the LSN modules is displayed.
Notice!
The numbers before the module names indicate the slot of the module on the panel.
1. Select the list field you require.
On the display, various possibilities for selection are offered:
2. Select:
– All info for one element to display all diagnostic information about an element on
one loop of an LSN module.
– Info for element group to display particular diagnostic information about several
elements of the selected LSN module.
– Info for all elements on the module to display particular diagnostic information
about all LSN elements of the selected LSN module.
The subsequent procedure for all three selection possibilities will be presented by means
of an example. The other two possibilities deviate only slightly from this.
Example:
1. Select Info for element group.
A list of the elements of the selected LSN module is displayed.
2. Select the required list fields.
The list fields are marked.
To Next Page
Loading...
