FPA-5000 | FPA-1200 | AVENAR panel 8000 |
AVENAR panel 2000 | AVENAR keypad 8000
For your information | en 9
Bosch Sicherheitssysteme GmbH
User Guide
2022-01 | 5.0 | F.01U.378.877
2 For your information
This user guide contains important information and notes on operating the AVENAR panel
8000/2000.
Using the step-by-step directions, you can familiarize yourself with the individual functions:
–
In overview, page 14
provides an overview of the operating and display elements and the
touch screen.
– In
Operating principle, page 21
, you will learn how to navigate through the individual
menus and which selection possibilities are available to you.
Each function is described in detail in an individual chapter.
You will find specific topics in the table of contents. If you are already practiced in the
handling of menus, you can use the overview of all menus in
All functions at a glance, page
12
.
Notice!
Panel Controller Firmware version 3.x
Two firmware versions are available for the panel controller of the fire panel: version 3.x and
version 4.x.This user guide is applicable for firmware panel version 3.x.
Firmware V3.x enables networking compatibility with the legacy FPA-5000 series panels
(MPC-xxxx-B and MPC-xxxx-C) and the FMR-5000 keypad.
This implies that when AVENAR panel and AVENAR keypad are running firmware V3.x, they
only contain bound product features and peripherals that are also available for the FPA-5000
series.
From January 1, 2022 to December 31, 2025, panel firmware version 3.x is in maintenance
mode. During this period, new versions will be released only containing fixes for critical bugs
and critical security gaps.
From January 1, 2022 onwards, new product features, new LSN peripherals, new GUI
languages, and normative changes will be only available in firmware version 4.x.
Firmware version 4.x is exclusively for AVENAR panel and AVENAR keypad.
2.1 What is new
The FPE-8000-SPC/PPC / FPE-2000-SPC/PPC is the successor panel of the AVENAR panel
8000/2000 modular fire panel.FPE-8000-SPC/PPC / FPE-2000-SPC/PPC combines a new and
powerful panel controller platform with all the well-known stable safety features.
When operating the FPE-8000-SPC/PPC / FPE-2000-SPC/PPC please note the following
important innovations:
Physical node address (PNA/RSN)
The physical node address of the panel is set in the panel firmware when switching on the
panel for the first time. The physical node address dialog replaces the mechanical rotary
switches.
For details see
Initial setup, page 22
.
Power button
The panel must be switched on and off with a power button which is located at the right side
of the panel. Also a reboot of the panel is done via the power button.
To Next Page
Loading...
