Bosch DIVAR IP all-in-one 6000 Installation Manual

24 en | Rack installation DIVAR IP all-in-one 6000
2022-10 | V02 | F.01U.407.903
Installation manual
Bosch Security Systems B.V.
5.2.3 Installing the outer rails in a round-hole threaded rack
To install the outer rails in a round-hole threaded rack:
1. Remove the screws, which secure the mounting brackets to the outer rail and remove the
mounting brackets at both ends of the outer rail.
2. Determine the position in the rack where you want to install the chassis.
3. Place the outer rail at the desired position inside the rack posts with the long section of
the outer rail toward the front rack post and the short section toward the rear rack post.
4. Align the holes on both ends of the outer rail with the holes in the rack posts.
5. Use proper screws to secure the outer rail to the rack posts.
6. Repeat these steps for the other outer rail.

Bosch DIVAR IP all-in-one 6000 Specifications

General

Brand	Bosch
Model	DIVAR IP all-in-one 6000
Category	Network Hardware
Language	English