Bosch DIVAR IP all-in-one 6000 Installation Manual

30 en | Installing a SATA hard drive DIVAR IP all-in-one 6000
2022-10 | V02 | F.01U.407.903
Installation manual
Bosch Security Systems B.V.
6.2 Installing a non-Bosch-supplied hard drive
i
Notice!
Bosch strongly recommends to use hard drives approved and supplied by Bosch. The hard
drives as one of the critical component are carefully selected by Bosch based on available
failure rates.
Bosch is not liable for any data loss or damages, or system failures of units equipped with
hard drives that are not supplied by Bosch.
Bosch cannot provide support if non-Bosch-supplied hard drives are considered to be the
cause of the problem. To troubleshoot potential hardware issues, Bosch will require Bosch-
supplied hard drives to be installed.
For more information about Bosch-supplied hard drives, see the datasheet in the Bosch
online product catalog under:
www.boschsecurity.com
Procedure
To install a non-Bosch-supplied hard drive, you must do the following:
1. Removing a hard drive tray from a hard drive bay, page 28 .
2. Installing a hard drive into a hard drive tray, page 31 .
3. Installing a hard drive tray into a hard drive bay, page 29 .
Removing a hard drive tray from a hard drive bay
To remove a hard drive tray from a hard drive bay:
1. Press the release button to the right of the hard drive tray. This extends the hard drive
tray handle.
2. Use the handle to pull the hard drive tray out of the chassis.
1
2
1 Release button 2 Hard drive tray handle

Bosch DIVAR IP all-in-one 6000 Specifications

General

Brand	Bosch
Model	DIVAR IP all-in-one 6000
Category	Network Hardware
Language	English