6 en | Safety DIVAR IP all-in-one 6000
2022-10 | V02 | F.01U.407.903
Installation manual
Bosch Security Systems B.V.
Notice!
If you install this device in an enclosure, make sure that the enclosure is adequately ventilated
according to the manufacturer’s instructions.
Caution!
Installation precaution
Do not place this device on an unstable stand, tripod, bracket, or mount. The device may fall,
causing serious injury to persons and damage to the device. Mount the device according to
the instructions of the manufacturer.
1.3 Electrical safety precautions
Warning!
Fire or electrical shock
Do not expose this device to rain or moisture to reduce the risk of fire or electrical shock.
Warning!
Power cable and AC adapter:
When installing the product, use the provided or designated connection cables, power cables
and AC adaptors. Using any other cables and adaptors could cause a malfunction or a fire.
Electrical Appliance and Material Safety Law prohibits the use of UL or CSA-certified cables
(that have UL/CSA shown on the code) for any other electrical devices.
Warning!
This product relies on the building's installation for short-circuit (overcurrent) protection.
Make sure that the protective device is rated not greater than: 250V, 20A.
Notice!
Safety Extra Low Voltage (SELV) circuits
All the input/output ports are SELV circuits. Connect SELV circuits only to other SELV
circuits.
Notice!
Power supplies
Operate the product only from the type of power source indicated on the label. Use only the
provided power supply or UL approved power supplies. Use a power supply according to LPS
or NECClass2.
Warning!
Make sure that the power supply cord includes a grounding plug and is plugged into a
grounded electrical outlet.
Notice!
Protect connection cables
Protect all connection cables from possible damage, especially at connection points.
To Next Page
Loading...
Need help?
General
