Bosch DIVAR IP all-in-one 6000 Installation Manual

DIVAR IP all-in-one 6000 System setup | en 35
Bosch Security Systems B.V.
Installation manual
2022-10 | V02 | F.01U.407.903
i
Notice!
Recorded video streams need to be configured in a way that the maximum bandwidth of the
system (BVMS/VRM base system plus iSCSI storage expansions) is not exceeded.
8.4 First sign-in and initial system setup
i
Notice!
Do not change any operating system settings. Changing operating system settings can result
in malfunctioning of the system.
i
Notice!
To perform administrative tasks, you must sign in to the administrator account.
i
Notice!
In case of password loss a system recovery must be performed as described in the
installation manual. The configuration must be done from scratch or must be imported.
To setup the system:
1. Connect the DIVARIPall-in-one unit and the cameras to the network.
2. Turn on the unit.
Setup routines for Microsoft Windows Server IoT 2022 for Storage Workgroup are
performed. This process can take several minutes. Do not turn off the system.
After the process is completed, the Windows language selection screen is displayed.
3. Select your country/region, the desired operating system language and the keyboard
layout from the list, then click Next.
The Microsoft software license terms are displayed.
4. Click Accept to accept the license terms and wait until Windows restarts. This can take
several minutes. Do not turn off the system.
After restart, the Windows sign-in page is displayed.
5. Set a new password for the administrator account BVRAdmin and confirm it.
Password requirements:
– Minimum 14 characters.
– At least one upper case letter.
– At least one lower case letter.
– At least one digit.
Then press Enter.
The Software Selection page is displayed.
6. The system automatically scans the local drive and any connected external storage media
for the DIVAR IP System Manager installation file SystemManager_x64_[software
version].exe, which is located in a folder with the following structure: Drive
root\BoschAppliance\.
The scan might take some time. Wait for it to complete.
7. Once the system has detected the installation file, it is displayed on the Software
Selection page. Click the bar that displays the installation file to start the installation.
8. If the installation file is not found during the scan process, proceed as follows:
– Go to https://downloadstore.boschsecurity.com/.

Bosch DIVAR IP all-in-one 6000 Specifications

General

Brand	Bosch
Model	DIVAR IP all-in-one 6000
Category	Network Hardware
Language	English