Bosch DIVAR IP all-in-one 6000 Installation Manual

34 en | System setup DIVAR IP all-in-one 6000
2022-10 | V02 | F.01U.407.903
Installation manual
Bosch Security Systems B.V.
8 System setup
The Microsoft Windows Server IoT 2022 for Storage Workgroup operating system provides a
user interface for initial server configuration, unified storage appliance management,
simplified setup and storage management, and support for Microsoft iSCSI Software Target.
It is specially tuned to provide optimal performance for network-attached storage. The
Microsoft Windows Server IoT 2022 for Storage Workgroup operating system provides
significant enhancements in storage management scenarios, as well as integration of storage
appliance management components and functionality.
DIVAR IP System Manager application is the central user interface that offers an easy system
setup, configuration and software upgrade.
i
Notice!
The following description is valid for DIVARIPall-in-one units that come with pre-installed
hard drives.
If you have installed hard drives to an empty unit, you first must configure them before
performing the initial setup.
Refer to
– Configuring new hard drives, page 38
8.1 Default settings
All DIVARIP systems are preconfigured with a default IP address and with default iSCSI
settings:
– IP Address: automatically assigned by DHCP (fallback IP address: 192.168.0.200).
– Subnet mask: automatically assigned by DHCP (fallback subnet mask: 255.255.255.0).
Default user settings for administrator account
– User name: BVRAdmin
– Password: to be set at first sign-in.
Password requirements:
– Minimum 14 characters.
– At least one upper case letter.
– At least one lower case letter.
– At least one digit.
8.2 Prerequisites
Observe the following:
– DIVARIP needs to have an active network link during installation. Make sure that the
network switch you are connecting to is powered on.
– The default IP address must not be occupied by any other device in the network. Make
sure that the default IP addresses of existing DIVARIP systems in the network are
changed before adding another DIVARIP.
8.3 Operation modes
DIVARIPall-in-one systems can operate in three different modes:
– Full video recording and management system, utilizing the BVMS and VRM core
components and services: This mode allows for advanced video management features
such as event and alarm handling.
– Pure video recording system, utilizing the VRM core components and services.
– iSCSI storage expansion for a BVMS or VRM system, which runs on a different hardware.

Bosch DIVAR IP all-in-one 6000 Specifications

General

Brand	Bosch
Model	DIVAR IP all-in-one 6000
Category	Network Hardware
Language	English