Bosch ICP-EZM2 - Power Supply Installation (Step 11); 2.11.1 EZPS Wire-In Power Supply

Easy Series (ICP-EZM2) | Installer Guide | 2.0 Installation
.
Bosch Security Systems, Inc. | 5/07 | F01U025147-01 19
2.11 Power Supply Installation (Step 11)
This system uses either the EZPS wire-in power supply, OR a plug-in power supply. Both power
supplies require the enclosure ground wire and a standby battery.
Follow the instructions below for the power supply used in your installation.
The EZPS is not investigated by UL.
2.11.1 EZPS Wire-in Power Supply
1. Mount the EZPS on the enclosure using
the screws supplied with the EZPS.
2. Connect the earth ground wire from the
EZPS to the enclosure stud.
L
N
EZPS
3. Connect AC power to the EZPS.
100-240 V
0.5 A MAX
47-62 Hz
L
N
EZPS