Bosch ICP-EZM2 - Basic Operation Information

Easy Series (ICP-EZM2) | Installer Guide | 1.0 Quick Reference
4 Bosch Security Systems, Inc. | 5/07 | F01U025147-01
1.3 Basic Operation Information
Item Description
House phone:
Press [#] three times, and enter a passcode.
Outside phone:
Dial the house phone number, and press [*] three times when the call is
answered. Enter a passcode.
Installer quick connect:
Connect a test telephone to the control panel’s test posts or telephone
terminals. Press and hold the system test button for approximately 15 sec. Enter
a passcode.
Start and end a
phone session
End a phone session:
Press [#] repeatedly until the system says “goodbye.”
Enter and exit
programming
Start a phone session (refer to options above).
Enter installer passcode when prompted.
From the Installer Menu, press [3] for basic programming, or [4] for expert programming.
- For Basic Programming, refer to Section 4.2 on page 30.
- For Expert Programming, refer to Section 4.3 on page 36.
To exit programming, press [#] repeatedly until you hear the system announce the Installer Menu options.
Passcode length
Options are four digits or six digits. Selection affects all passcode lengths.
Expert programming →Expert Programming Item Number 861.
Installer
passcode
Four-digit default = 5432; six-digit default = 543211 (Expert Programming Item Number 7011).
Master user
passcode
Four-digit default = 1234; six-digit default = 123455. (Expert Programming Item Number 7001).
Factory default
In expert programming, enter Expert Programming Item Number 9999. Doing this restores all factory default
values. All programming items, except for the country code, are reset when you restore the factory default
values. All recorded speech items are unaffected.
Add or change
users
Start a phone session, or press and hold [3] on the control center (refer to Section 1.2 Control Center
Overview on page 3).
Enter the master user passcode.
Press [4] to select the User Menu.
Press [1] to add a new user, or press [3] to change an existing user. Follow all voice prompts.
When you add a new user or change an existing user, you can also assign a token or key fob.
System Test On the control panel board, press the System Test button once to start the System Test.
“Call for
Service” Details
Enter the installer passcode when you hear the “Call for Service” message.
The system announces the system trouble condition and then asks you to select a menu option.