Easy Series (ICP-EZM2) | Installer Guide | 3.0 Point Expansion
28 Bosch Security Systems, Inc. | 5/07 | F01U025147-01
3.3 Wireless System Messages
Refer to the following table for a description of system messages that pertain to the wireless network.
System Message Description
“Wireless devices not configured.” Point Test was exited before all wireless points were tested.
“Extra device ignored.”
An attempt was made to add a device to a system that already contains
the maximum number of points or outputs.
“Point x was tested.” A point was tested. RFSS is acceptable.
“Point x low.” A point was tested. RFSS is unacceptable.
“Please wait.”
The wireless network is busy, or the control panel is waiting for the
wireless network to respond.
The control center might show a single rotating segment of the circle of
protection with this message.
“Wireless error.”
The wireless hub is jammed, missing, or experiencing a trouble
condition.
“Wireless devices x.” “x” = the number of devices that are discovered, but not tested.
“Wireless devices not tested x.” “x” = the number of devices that are discovered, but not yet configured.
“Point x not tested.” The control panel assigned a point number to the device, but the device
was not tested (faulted, or tampered, and restored).
“x” = the voice description.
By default, the system announces the point number.
To Next Page
Loading...
