Bosch ICP-EZM2 - 1 0 Quick Reference; System Overview; Control Center Overview

Easy Series (ICP-EZM2) | Installer Guide | 1.0 Quick Reference
.
Bosch Security Systems, Inc. | 5/07 | F01U025147-01 3
1.0 Quick Reference
1.1 System Overview
2
1
12 VDC
C =0V
C =12V
C =
NC
CNO
2345678
1
Connect either a two-wire smoke detector or an intrusion detector, such as a motion detector, to Point 1.
2
Use either the EZPS wire-in power supply or a transformer.
1.2 Control Center Overview
9
8
7
6
5
4
3
1
2
Callout Description
1
Press and hold [1] for two sec to start a fire alarm.
For an emergency alarm, press and hold [1] and [2] for two sec.
2 Press and hold [2] for two sec to start a panic alarm.
For an emergency alarm, press and hold [1] and [2] for two sec.
3 Press and hold [3] for 2 sec to enter User Menu, and then present token or enter passcode. Select an option
1
:
• Add User:
Press [1]. Use this option to add a new user. You must assign a passcode. You can
also record a description and assign a token or key fob. Follow all voice prompts.
• Change User:
Press [2]. Use this option to add or change the passcode, description, token, or key fob
assigned to an existing user. Follow all voice prompts.
• Delete User:
Press [3].
4 Press and hold [4] for 2 sec to turn Chime Mode on or off.
5
Press and hold [5] for 2 sec to enter Volume Menu, and then press again to select a level: low, medium, high, or
quiet
2
.
6 Press [i] to turn the system on or off. Follow all voice prompts.
7 Speak into the audio interface to talk to someone on the telephone during a two-way voice session.
8 Present token to control center to turn the system on or off.
9 Control center display. Refer to Section 7.5 Display States on page 62 for more information.
1
Master user token or passcode required to access these options. Other users can change only their own passcodes.
2
Quiet Control Center: Exit Delay and Entry Delay tones are silenced.