Bosch ICP-EZM2 - Installer Phone Menu

Easy Series (ICP-EZM2) | Installer Guide | 1.0 Quick Reference
6 Bosch Security Systems, Inc. | 5/07 | F01U025147-01
1.5 Installer Phone Menu
Installer
Phone
Menu
Programming
Key
Custom
Messages
Two-Way
Voice Session
Expert
Programming
Basic
Programming
User Menu
System
Maintenance
Event history
System test menu
1 Set date and time
Full system test
Reset system
2
3
Exit system test menu
Warning device test
Battery test
Communication test
Control center test
Point test
1
2
3
4
5
#
Points
Report Configuration
Outputs
Country Code
Exit basic programming
1
2
3
4
#
4
5
Exit system maintenance
#
Change installer passcode
Change master user (User 1) passcode
Exit user menu
1
2
#
Record point description
Set point type
Exit points
1
2
#
Enter account number
Configure report destinations
Exit report configuration
1
2
#
Select output function
Exit outputs
1
#
Enter programming item, enter selection.
Talk to person at control center
Listen to person at control center
End voice session
1
2
#
Record site description
Record call for service message
Exit custom messages
1
2
#
Send data from key to control panel (key position = )
Send data from control panel to key (key position = )
Exit programming key
1
2
#
Exit installer menu and end phone session.
Installer passcode
4-digit default: 5432
6-digit default: 543211
4
5
6
7
#
1
Most recent events
Events by date
Last 10 events
Last alarm event
Exit event history
1
2
3
4
#
Operate Outputs6
3
Wireless configuration
6
}
The voice session only lasts 90 seconds.
To reset the timer, press [1] on the phone during talk mode, or
[2] during listen mode.
Only the person on the phone can switch between talk and listen
modes.
}
Custom messages are stored in the voice module, and are not
saved with the control panel's programming data.
2
Exit Wireless configuration
Replace a device
Add a device
Delete a device
Transfer wireless data
(control panel-to-hub)
1
2
3
4
5
#
Erase and discover6
Transfer wireless data
(hub-to-control panel)
=
The system’s arming status (on or off) and Expert Programming Item Number 142’s setting of (0 or 1)
determines the availability of these menu items.