Easy Series (ICP-EZM2) | Installer Guide | 4.0 Programming
.
Bosch Security Systems, Inc. | 5/07 | F01U025147-01 41
4.3.3 Communicator Programming Items
To enable reporting, configure the following programming items:
• Account Number (Expert Programming Item Number 100)
• Route 1 Primary Destination (Expert Programming Item Number 206)
• Route 1 Backup Destination (Expert Programming Item Number 207) – optional
• Route 2 Primary Destination (Expert Programming Item Number 208) – optional
• Route 2 Backup Destination (Expert Programming Item Number 209) – optional
• Format for Route 1 Primary Destination (Expert Programming Item Number 211)
• Format for Route 1 Backup Destination (Expert Programming Item Number 212) – optional
• Format for Route 2 Primary Destination (Expert Programming Item Number 213) – optional
• Format for Route 2 Backup Destination (Expert Programming Item Number 214) – optional
To enable or disable reports, refer to Section 4.3.4 Report Routing Programming Items on page 43.
Programming Item
Item
Number
Description (Range) Entry
000000
Account Number 100
Enter a 4- or 6-digit account number (0000 to FFFFFF).
Valid digits are 0 to 9 and B to F. Do not use “A.”
Phone Line
Supervision
201 0 = Phone line is not supervised.
1 = Phone line is supervised.
0
Voice Format Repeat
Count
203
Enter the number of times the system repeats a voice report
during the phone call (1 to 15).
3
Voice Format Message
Delivery Attempts
204
Enter how many times the system attempts to deliver a voice
format message (1 to 5).
The time delay between delivery attempts increases by 5 sec.
1
Dial Tone Detect 205 0 = Do not wait for dial tone before dialing central station.
1 = Wait for dial tone before dialing central station.
1
0
Route 1 Primary
Destination
206
0
Route 1 Backup
Destination
207
0
Route 2 Primary
Destination
208
0
Route 2 Backup
Destination
209
Enter a phone number for each destination (up to 32 digits):
0 to 9 = [0] to [9]
* = [*][*]
# = [*][#]
Pause = [*][1]
Exit with save = [#]
Exit without save = [#][#]
Press [#] twice within two seconds to exit without saving your
entry.
Disable phone number = [0][#]
0
SMS Service Provider
Number
210
Enter your cellular phone service provider’s phone number for
text messaging (up to 32 digits).
For SMS providers that support TAP protocol, contact your
cellular provider, or visit www.notepager.com/tap-phone-
numbers.htm
Format for Route 1
Primary Destination
211
0
Format for Route 1
Backup Destination
212
0
Format for Route 2
Primary Destination
213
0
Format for Route 2
Backup Destination
214
0 = Disabled
1 = Contact ID
2 = SIA
3 = Voice
4 = SMS Text (TAP)*
5 = Fast Format
* Refer to page 32 for SMS text messages.
SMS providers do not guarantee delivery of SMS text
messages.
0
Default
= Country-specific default. Select this programming item to hear the updated default value.
To Next Page
Loading...
