Bosch Intuvia 100 - Page 102

MY23P0a -52_1.0_11.10.2022
102
Description
Crank bearing/crank set
Conventional cartridge crank bearing
35–45 Nm
…
SHIMANO, HOLLOWTECH Ii/two-
part crank set
Linker for adapter and inner sleeve 35–50 Nm TL-FC24/TL-FC25/TL-FC32/TL-FC36
SHIMANO, HOLLOWTECH Ii/two-
part crank set
Cap 0.7–1.5 Nm TL-FC16 / TL-FC18
SHIMANO, HOLLOWTECH Ii/two-
part crank set
Screw for left-hand crank arm 12–14 Nm Hex key, 5 mm
SHIMANO, OCTALINK model
Linker for adapter and main body 50–70 Nm TL-UN74-S/ TL-UN66
SHIMANO, OCTALINK model
Crank set
35–50 Nm
Hex key, 8 mm
Hex key, 10 mm
SHIMANO, SQUARE model
Linker for adapter and body 50–70 Nm TL-UN74-S
SHIMANO, SQUARE model
Crank set 35–50 Nm
Hex key, 8 mm
Handlebars
Clamping screw, conventional 5 … 7 Nm* #
CONTROL TECH, handlebar clamp
with one or two screws 14 … 16 Nm #
SHIMANO,
Handlebar clamp with one or two
screws
20 … 29 Nm #
Motor
FIT, Brose S-Mag FIT
Motor attachment screws
(horizontal/vertical)
23/24 Nm #
FIT, Panasonic FIT
Motor attachment screws
20 ... 24 Nm #
BOSCH motor BDU37xx
6 x attachment screws for motor
20 ± 2 Nm Torx Plus® P40, M8 × 16
BOSCH Intuvia 100 bracket
Motor cover
BOSCH motor cover BDU37xx
Attachment screws for lower motor
cover
Attachment screws for motor cover
Initial fitting: 3 ± 0.5 Nm
Retrofit: 2 ± 0.5 Nm
Initial fitting: 3 ± 0.5 Nm
Retrofit: 2 ± 0.5 Nm
Torx® TX 20
Torx® TX 20, 4 × 8 mm
Brose FIT motor cover 1 Nm #
Torx ® Torx Plus ®