MY23P0a -52_1.0_11.10.2022
175
Operation
6.6.5 Front baskets
6.6.6 Bar ends
6.6.7 Kickstands
We recommend a parking stand into which either
the front wheel or rear wheel can be inserted
securely for pedelecs which do not have a
kickstand.
6.6.8 Additional battery headlight
6.6.9 Mobile holder
A holder for SP Connect mobile case is fitted to
the stem.
Observe the operating instructions for the mobile
and the SP Connect mobile case.
Use on tarmacked roads only.
Protect mobile from theft.
To attach: insert the SP Connect mobile case
in the holder and turn 90° to the right.
To release: turn the SP Connect mobile case
90° to the left and remove.
6.6.10 Suspension fork coil spring
If the desired suspension fork sag cannot be
achieved after adjustment, the coil spring
assembly must be replaced with a softer or harder
spring.
Fit a softer coil spring assembly group to
increase the sag.
Fit a harder coil spring assembly group to
decrease the sag.
6.6.11 Fixed weather protection systems
Take care with front baskets because their load
distribution is not fixed. They are only permitted
with the vehicle manufacturer’s approval and
only if they are approved for use on e-bikes.
Handlebar ends are permissible provided they
are professionally fitted to face the front at a
specialist shop and only if they are approved for
use on e-bikes. They must not seriously alter
load distribution.
Kickstands are permitted if they are able to bear
the weight of the pedelec.
Fitting additional battery headlights is permitted
provided they comply with the laws of the country
where the pedelec will be ridden and if they are
approved for use on e-bikes.
Fixed weather protection systems are only
permitted with the vehicle manufacturer’s
approval.
To Next Page
Loading...
