Bosch Intuvia 100 - Switching the SHIMANO Derailleur Gear MTB Shifter

MY23P0a -52_1.0_11.10.2022
195
Operation
6.21.2 Switching the SHIMANO derailleur
gear MTB shifter
The speed and range can be increased while
applying the same force if you select the right
gear.
 Stop pedalling briefly when changing gears. This
makes it easier to switch gears and reduces wear
on the drivetrain. However, keep the crank
moving while switching gears.
Figure 183: Switching gears with lever A, using gear shift
SL-M5000 as an example
Lever A switches up from the smallest sprocket to
the largest sprocket.
 Place shifter A in position 1.
 System shifts one sprocket higher.
 Place shifter A in position 2.
 System shifts two pinions higher.
Figure 184: Switching gears with lever B, using gear shift
SL-M5000 as an example
Lever B switches up from the largest sprocket to
the smallest sprocket. There are two ways to
switch down a gear:
 Place shifter B in position 1.
 System shifts one sprocket lower.
 Place shifter B in position 2.
 System shifts one sprocket lower.
Switching gears
 Select the appropriate gear with the gear shift
unit.
 The gear shift switches gear.
 The shifter returns to its original position.
 Clean and lubricate the rear derailleur if gear
changes block.
1
2
2
1