Bosch Intuvia 100 - Adjusting the SR Suntour Compression Damper

MY23P0a -52_1.0_11.10.2022
185
Operation
6.16.3.1 Adjusting the SR Suntour compression damper
Only applies to pedelecs with this equipment
Figure 169: Position of RS Suntour compression adjuster on rear frame dampers Triair2 (a), Triair (b), EDGE-comp (c) and
EDGE (d)
 The pedelec’s sag is configured.
 The pedelec’s rebound damping has been set.
 Adjust the compression damper to the terrain
before setting off.
 Set the compression adjuster to the required
mode.
1
abc d
Mode Use
1 OPEN Ideal for setting off
The rear frame damper quickly deflects
unhindered through its entire deflection
range.
2 THRESHOLD Ideal for saving energy while riding on
roads and/or for maximum pedalling
efficiency on flat or smooth terrain.
When the threshold is activated, the rear
frame damper counteracts deflection until
a medium bump or downward force
occurs.
3 LOCK Tarmacked roads
(see Section 6.16.1) The locked rear
frame damper counteracts deflection until
a strong impact or upward force occurs.
Crash caused by damaged rear frame damper
The rear frame damper can be damaged if it is
compressed under high stress load. This may
lead to an accident with injuries.
 Never select the LOCK setting on off-road
rough terrain or when the suspension is
subject to high stress loads.
CAUTION
!