MY23P0a -52_1.0_11.10.2022
116
Assembly
5.3.3 Adjusting the LIMOTEC seat post
Only applies to pedelecs with this equipment
The rider’s body weight exceeds or falls below the
seat post’s functional weight.
1 Order new Limotec seat post with suitable
functional weight.
2 Remove existing seat post.
Replacing Limotec A1 and A5
3 Use the seat height formula to calculate the
optimum seat post height for leg length:
Seat height (SH) = inner leg length (I) × 0.9
4 Lower the seat post further into the seat tube.
5 Tighten the seat post Bowden cable in the
frame up to the remote control to the same
length as the seat post was lowered.
6 Trim the seat post Bowden cable on the
handlebars if necessary.
To Next Page
Loading...
