Bosch Plena - Page 140

4 General Requirements
Clause / Requirement Compliance Signature
4.1 General Plena is compliant.
4.1.1 If an optional function with
requirements is included in the VACIE,
then all the corresponding requirements
shall be met (see Annex B).
The following optional functions,
with requirements, are included in
Plena Voice Alarm System:
– Audible warning (7.3)
– Manual silencing of the voice
alarm condition (7.6.2)
– Manual reset of the voice alarm
condition (7.7.2)
– Voice alarm condition output
(7.9)
– Indication of faults related to
the transmission path to the CIE
(8.2.6)
– Indication of fault related to
voice alarm zones (8.2.7)
– Voice alarm manual control (10)
– Emergency microphone(s) (12)
– Microphone priority (12.2)
– Redundant power amplifiers
(13.14)
The following optional functions
with requirements are not included
in Plena Voice Alarm System:
– Delay(s) to entering the voice
alarm condition (7.4)
– Phased evacuation (7.5)
– Output to fire alarm devices
(7.8)
– Disabled condition (9)
– Interface to external control
device(s) (11)
4.1.2 If functions other than those
specified in this European Standard are
provided, they shall not jeopardize
compliance with any requirements of
this European Standard
4.2 Combined VACIE and CIE
When the VACIE and CIE are combined
they may share common indications,
manual controls and outputs (see
Annex F). In this case, the following
shall apply:
This requirement is not applicable.
In Plena Voice Alarm System, the
Voice Alarm Control and Indicating
Equipment (VACIE) is not combined
with a fire alarm Control and
Indicating Equipment (CIE).
140 en | Appendices Plena
2013.07 | V2.0 | Installation and Operation manual Bosch Security Systems B.V.