Figure 4.5: Trigger input indication
5. In the configuration program, set the Action Programming for the relevant input to Fault
and EOL.
6. Enter the Zone or Zone group that is monitored by the EOL board. The Zone group can be
All Zones (of the Controller/Router), Zone 1‑3 or Zone 4‑6. Fault Type and Zone will
define the visual indication on the unit in case of a fault.
7. Set the Action to Open and Type to Momentary.
Plena Installation | en 47
Bosch Security Systems B.V. Installation and Operation manual 2013.07 | V2.0 |
To Next Page
Loading...
