Bosch Plena - Page 6

6.4.3 Speech filter 84
6.4.4 Termination 84
6.5 Remote control 85
6.5.1 Remote control ID 85
6.5.2 Monitor 85
6.5.3 Termination switch 85
6.6 Remote control extension 86
6.6.1 Remote control extension ID 86
6.6.2 Termination switch 86
7
Operation 87
7.1 Switch on 87
7.1.1 Voice alarm controller 87
7.1.2 Voice alarm router 87
7.1.3 Calibration 87
7.2 Background music 88
7.2.1 Select BGM source 88
7.2.2 Select zones 88
7.2.3 Adjust volume 89
7.2.4 Adjust frequencies 89
7.3 Business calls 89
7.3.1 Select zones 90
7.3.2 Make the announcement 90
7.4 Emergency state 91
7.4.1 Enter the emergency state 91
7.4.2 Acknowledge the emergency state 92
7.4.3 Exit the emergency state 92
7.4.4 Distribute live speech 92
7.4.5 Select zones 93
7.4.6 Make the announcement 94
7.4.7 Distribute the alert message 94
7.4.8 Distribute the alarm message 96
7.5 Fault State 96
7.5.1 Acknowledge the fault state 96
7.5.2 Reset the fault state 97
7.5.3 Fault indicators 98
8
Troubleshooting 101
8.1 Introduction 101
8.2 Message or chime does not sound 101
8.3 No pilot tone detected on EOL board 101
8.4 No pilot tone detected on power amplifier 101
8.5 No BGM on the router 101
8.6 No BGM on controller or router 101
8.7 No sound coming from the router 102
8.8 Volume override only working for EMG, not for business calls (or similar problems) 102
8.9 False Ground Short fault 102
8.10 Start/Stop function on Trigger Inputs 102
8.11 Processor Reset 103
8.12 USB port not connected 103
8.13 Data fault during configuration upload 103
6 en | Table of Contents Plena
2013.07 | V2.0 | Installation and Operation manual Bosch Security Systems B.V.