Notice!
If no additional action is taken within 10 seconds after the last Zone select button has been
pushed (for example pushing the Alert message button), the zone selection is cancelled.
Figure 7.15: Zone select buttons
To select all zones, push the All call button on the front panel of the voice alarm controller or
the remote controls.
Figure 7.16: All call button
Start the alert message
Push the Alert message button on the front of the voice alarm controller or the remote
controls to distribute the default alert message. The message is only distributed to the
selected zones.
– If the red Alert message indicator is off, the alert message is not distributed. Push the
Alert message button to distribute the default alert message.
– If the red Alert message indicator is on, the message is distributed. Push the Alert
message button to stop distributing the default alert message.
Figure 7.17: Alert message button
Plena Operation | en 95
Bosch Security Systems B.V. Installation and Operation manual 2013.07 | V2.0 |
To Next Page
Loading...
