To Next Page

To Previous Page

7-12 Basic parameterization REFUspeed RS51

DOK-RD500*-RS51*******-IB02-EN-P

Parame-

ter No.:

Name Description / explanation

selectable options

Factory setting

min ... max values

Pass

wor

0762 Time, timer Supplementary parameter for “setpoint in the tolerance

bandwidth”.

1.0 sec 2

Time for the timer 0.0 ... 650.0 sec

1206 ALM sparking Supplementary parameter for “O ALM sparking signal” Inverted 2

0=direct

1=inverted

0...1

1220 ALM load limit Supplementary parameter for “O ALM load limit” Inverted 2

0=direct

1=inverted

0...1

0876 Dig. in-, output2

I WLM sensitivity

As for parameter 0875 0...97

0463 Mode dig. output Supplementary parameter for P0876 for all output

functions

Output, direct 1

0 = output direct

1 = output inverted

0...1

0877 Dig. in-, output3

I WLM sensitivity

down

As for parameter 0875 0...97

0465 Mode dig. output Supplementary parameter for P0877 for all output

functions

Output, direct 1

0 = output direct

1 = output inverted

0...1

0878 Digital input4

I parset bit4

As for parameter 0875, from value 0 bis 69. 0...67

0879 Digital input5 Fault acknow-

ledgement