1 689 989 261 2019-04-08| Robert Bosch GmbH
Symbols used | SMT 300 | 21
1. Symbols used
1.1 In the documentation
1.1.1 Warning notices - Structure and meaning
Warning notices warn of dangers to the user or people
in the vicinity. Warning notices also indicate the con-
sequences of the hazard as well as preventive action.
Warning notices have the following structure:
Warning
symbol
KEY WORD – Nature and source of hazard!
Consequences of hazard in the event of fail-
ure to observe action and information given.
¶ Hazard prevention action and information.
The key word indicates the likelihood of occurrence and
the severity of the hazard in the event of non-observance:
Key word Probability of
occurrence
Severity of danger if in-
structions not observed
DANGER Immediate impend-
ing danger
Death or severe injury
WARNING Possible impending
danger
Death or severe injury
CAUTION Possible dangerous
situation
Minor injury
1.1.2 Symbols in this documentation
Symbol Designation Explanation
!
Attention Warns about possible property damage.
i
Information Practical hints and other
useful information.
1.
2.
Multi-step
operation
Instruction consisting of several steps.
e
One-step
operation
Instruction consisting of one step.
Intermediate
result
An instruction produces a visible inter-
mediate result.
"
Final result There is a visible final result on com-
pletion of the instruction.
2. Important notes
Before start up, connecting and operating
Bosch products it is absolutely essential
that the operating instructions/owner’s
manual and, in particular, the safety in-
structions are studied carefully. By doing so you can
eliminate any uncertainties in handling Bosch products
and thus associated safety risks upfront; something
which is in the interests of your own safety and will
ultimately help avoid damage to the device. When a
Bosch product is handed over to another person, not
only the operating instructions but also the safety
instructions and information on its designated use must
be handed over to the person.
2.1 User group
The product may be used by skilled and instructed per-
sonnel only. Personnel scheduled to be trained, famil-
iarized, instructed or to take part in a general training
course may only work with the product under the su-
pervision of an experienced person.
All work conducted on electrical and hydraulic devices
may be performed by persons with sufficient knowledge
and experience in the field of electrics and hydraulics.
Children have to be supervised to ensure that they do
not play with the appliance.
1.2 On the product
! Observe all warning notices on products and ensure
they remain legible.
en
¶ Read sec.3 for a detailed explanation of the warning
signs on the product.
Risk of burns
When working with SMT 300, the handle
and surface poses a burn hazard. SMT 300
can reach a temperature of up to 60°C
when used for an extended period of time.
Danger from laser beam
The laser beam emitted by the
multi-function lamp can blind
individuals, cause accidents,
or damage the eye.
To Next Page
Loading...
