MY22Z0a - 12_1.0_25.07.2022
113
Operation
6.5.4.4 Setting the saddle height with the
remote control
Use the seat height formula to set the saddle
height:
Seat height (SH) = inner leg length (I) × 0.9
Lowering the saddle
1 Sit on the saddle.
2 Press the remote control operating lever.
The seat post will lower.
3 Release the remote control operating lever
when you have reached the desired height.
Figure 120: Remote control operating lever (1)
Raising the saddle
1 Remove any pressure from the saddle.
2 Press the remote control operating lever.
The seat post will rise.
3 Release the remote control operating lever
when you have reached the desired height.
Notice
If you are unable to achieve the required saddle
height, the seat post must be lowered further into
the seat tube. The seat post Bowden cable must
be tightened in the frame up to the remote control
to the same length as the seat post was lowered.
If this is not possible, contact your specialist
dealer.
To Next Page
Loading...
