MY22Z0a - 12_1.0_25.07.2022
174
Operation
6.22 Parking the pedelec
1 Switch off the drive system (see
Section
6.17.2).
2 After getting off, use your foot to lower the
kickstand completely before parking. Ensure
that it is stable.
3 Park the pedelec carefully and check that it is
stable.
4 Cleaning the suspension fork and pedals (see
Section
7.2.2.)
5 Protect the saddle with a saddle cover if you
park the pedelec outside.
6 Secure the pedelec with a bicycle lock.
7 Remove the battery (see Section
6.16.1.1,
6.16.2.1
or 6.16.3.1) and, where necessary,
your mobile (see Section
6.6.3) to ensure
protection against theft.
8 Clean and service pedelec after every ride; see
Section 7.2
.
Check list after each ride
Notice
Heat or direct sunlight can cause the tyre pressure
to increase above the permitted maximum
pressure. This can destroy the tyres.
Never park the pedelec in the sun.
On hot days, regularly check the tyre pressure
and adjust it as necessary.
Moisture penetrating at low temperatures may
impair individual functions due to the open
structural design.
Always keep the pedelec dry and free from
frost.
If the pedelec is to be used at temperatures
below 3 °C, the specialist dealer must carry
out an inspection and prepare it for winter use.
The pedelec's force of weight may cause the
kickstand to sink into soft ground, possibly
causing the pedelec to topple over as a result.
Park the pedelec on firm, level ground only.
Cleaning
Lights and reflectors See Section 7.2.5
Brake See Section 7.2.5
Suspension fork See Section 7.2.1
Suspension seat post See Section 7.2.6
Rear frame damper See Section 7.2.7
Pedal See Section 7.2.4
Care
Suspension fork See Section 3.
To Next Page
Loading...
