MY22Z0a - 12_1.0_25.07.2022
80
Transportation and storage
4.4.4 Break in operation
Remove the on-board computer and battery
from their mount if the pedelec is not going to
be used for up to four weeks.
If the pedelec is removed from service for
longer than four weeks, you need to prepare it
for a break in operation.
New battery
Inspect battery for damage after delivery.
If the batteries are damaged, observe
Section 2.1 Handling a damaged or faulty
battery during storage and disposal.
It is best to store damage-free batteries
separately for 24 hours and keep them under
observation.
4 If no faults arise, store batteries in a separate
room with fire doors and smoke detectors.
If the battery is stored in its original
packaging, stack a maximum of five batteries
on top of one another.
Battery in use
1 Immediately remove batteries from customer
pedelec before maintenance or repair.
Treat unchecked batteries as faulty
batteries.
When storing batteries, treat them in the
same way as a damaged or faulty battery until
they are inspected.
2 Inspect battery.
3 Battery are stored as agreed with the
insurance company.
Defective battery
If batteries are faulty, observe Section 2.1
Handling a damaged or faulty battery during
storage and disposal.
Notice
The battery discharges when not in use. This can
cause irreparable damage to the battery.
The battery must be recharged every
6 months.
The battery may become damaged if it is
connected permanently to the charger.
Never connect the battery to the charger
permanently.
If the battery is stored for a longer period of time
when empty, it can become damaged despite low
self-discharge and power storage capacity can be
greatly reduced.
Store battery with at least 30% charge.
To avoid an extremely low charge level in the
integrated battery in the LED remote and the
system controller, charge components every 3
months for around 1 hour via the USB
diagnostic interface.
To Next Page
Loading...
