40
11.Repeat steps 5-10 to sample the desired phrases.
*
You may skip step
6,
because when you
sample
,
the SP-
202 automatically selects
a
pad to which no sample has
been assigned.
e.
Press
the
DEL
button.
The DEL button will light. When it goes dark, the delete
operation has been completed.
*
Never turn the power off while the DEL button is lit.
b.
Press the pad whose sample you wish to delete.
(Pad
will
blink)
a.
Press the DEL
button.
(The
button
will
blink)
Delete the sound that you sampled and try the procedure
again from step
5.
The delete procedure is as follows.
e
If
you don't like the sound you sampled
*
If
there is an interval of silence at the beginning of the
sound or an unwanted portion at the end of the sound
when you playback, you can use the editing operation
described in the section "Playing only the desired por-
tion of a sound" (page
27)
so that only the desired
por
-
tion is heard.
10.
When
you wish to stop sampling, press the SAM·
PLING START/STOP button. Sampling will end,
and
the
blinking
pad will go dark.
Press the pad and listen to the sound that you just sam-
pled.
If
the sound is satisfactory, press the pad to stop
playback (the pad will go dark), and continue with step
11.
9.
Start playback of the CD,
and
in synchronization
with
the beginning of the desired sound from the
CD, press the SAMPLING START/STOP button.
The REC button will light, and sampling will begin.
8.
Stop
the
CD player, and put
it
once again in play-
back
standby
mode.
7.
Adjust the
sampling
level.
Start playback on the CD, and rotate the REC LEVEL
knob to adjust the level so that PEAK lights occasionally.
6,
Press
the
BANK INT A/B
button
(or
if you
are
using a memory card, the CARD
CID
button) and
a pad to specify the
pad
and
bank
to which
the
sampled
sound
will be assigned.
The selected
pad
will blink.
*
Even if you
press
a
pad to which
a
sample is
already
assigned, it will not blink.
*
If
you decide to cancel the sampling operation, press the
CANCEL button. The REC button will go dark.
5,
Press the SAMPLING ST ART/STOP
button.
The REC
button
will blink, and the SP-202 will be in
standby mode. ,At this time,
a
pad to which no sample
has been assigned will be selected automatically and will
blink.
4.
Make sure
that
the SP-202's SOURCE
MIX
switch
is OFF and
that
the SOURCE SELECT switch is
LINE,
and then turn
the SP-202's
power switch
ON.
3,
Set the SOURCE SELECT switch to LINE.
2,
Tum on the
power
of the CD player, and
put
the
CD in
playback standby
mode.
1,
Connect your CD player. (page
8, 9)
I
Sampling
various phrases
This section will explain how to create break-beats, and the
basic procedure of how to connect these to create
a
song.
Using the SP-202's Time Stretch function which allows you
to modify the tempo
without
affecting the pitch,
it's
also
easy to connect phrases whose tempo is different.
*
Unauthorized sampling from
a
CD, record, tape, video
production, or broadcast etc. whose copyright is owned
by a third party is forbidden by law, with the exception
of special cases such as private use.
You can sample
a
variety of basic phrases of
a
few measures
(mainly
rhythms)
from
various
songs, and use them as
break-beats.
Section
7.
Creating break-beats
To Next Page
Loading...