Brady BradyPrinter i7100 - Cleaning; Cleaning Information; Approved Cleaning Swabs; Cleaning the Print Roller

26
User Manual
9 Cleaning
9.1 Cleaning Information
Danger!
Risk of death via electric shock!
 Disconnect the printer from the power supply before performing any maintenance work.
Thelabelprinterrequiresverylittlemaintenance.
Itisimportanttocleanthethermalprintheadregularly.Thisguaranteesaconsistentlygoodprintedimageandplaysa
majorpartinpreventingprematurewearoftheprinthead.
Otherwise,themaintenanceislimitedtomonthlycleaningofthedevice.
!
Attention!
The printer can be damaged by aggressive cleansers.
Do not use abrasive cleaners or solvents for cleaning the external surfaces or modules.
 Removedustandpaperufffromtheprintareawithasoftbrushorvacuumcleaner.
 Thecoveroftheprintercanbecleanedwithastandardcleanser.
9.2 Approved Cleaning Swabs
UseBrady part number PCK-6cleaningswabspre-soakedinprintheadcleaningsolution.Packageof50swabs.To
beusedtocleanprinthead,sensor,rollers.
9.3 Cleaning the Print Roller
Accumulationsofdirtontheprintrollermayimpairthemediatransportandtheprintquality.
 Lifttheprinthead.
 Removelabelsandtransferribbonfromtheprinter.
 Removedepositswithrollercleanerandasoftcloth.
 Iftherollerappearsdamaged,replaceitServiceManual.
9.4 Cleaning the Printhead
Cleaningintervals: directthermalprinting -everymediarollchange
   thermaltransferprinting -everyribbonrollchange
Substancesmayaccumulateontheprintheadduringprintingandadverselyaffectprinting,e.g.differencesincontrast
orverticalstripes.
!
Attention!
Printhead can be damaged!
Do not use sharp or hard objects to clean the printhead.
Do not touch protective glass layer of the printhead.
!
Attention!
Risk of injury from the hot printhead line.
Ensure that the printhead has cooled down before starting cleaning.
 Lifttheprinthead.
 Removelabelsandtransferribbonfromtheprinter.
 Cleanprintheadsurfacewithspecialcleaningpenoracottonswabdippedinpurealcohol.
 Allowprintheadtodryfor2–3minutesbeforecommissioningtheprinter.