M611 Label Printer User Manual 25
Setup
Accessories
Dispose in accordance with federal, state, and local regulations.
To attach the magnet accessory to the printer:
1. Position the magnet accessory over the screw hole on the bottom of the printer.
2. Flip up the handle on the screw and
use it to hand tighten the screw.
3. Slide the magnet keeper plates off
of the magnets.
• Do not give children strong magnets (especially neodymium). Keep this
product out of the reach of children.
• Many magnets are brittle and may shatter if they “jump” together or jump onto
a steel surface. Always wear eye protection if this is likely to happen.
• Analog watches, televisions, and computer monitors can be permanently
damaged by placing magnets near them.
• Strong magnets may affect or interfere with sensitive electronic instruments
and navigation equipment. Always keep magnets a sufficient distance from
such devices.
• Magnets can destroy information stored on magnetic media such as credit
cards, tape drives, and computer hard drives. To preserve your data, keep
these and other magnetic media away from the product.
To Next Page
Loading...
