M611 Label Printer User Manual 38
Maintenance
Replacing the Cutter Blade Cover
To remove the cutter blade cover:
1. From inside the supply well, slip your finger
under the right side of the blade cover and
gently pull up to unhook the blade cover.
The blade cover releases easily.
To re-insert the cutter blade cover:
1. Grasp the blade cover from the
top with the cut-out portion of the
blade facing the display screen
(away from the supply well).
2. Pull the yellow flap forward, then
insert the blade tight up against
the yellow flap with the metal tabs
fitting over the outside of the
cutter housing.
The blade cover snaps in easily.
To Next Page
Loading...
