EasyManuals Logo

Brocade Communications Systems FastIron X Series Hardware Installation Guide

Brocade Communications Systems FastIron X Series
216 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #67 background imageLoading...
Page #67 background image
Brocade FastIron X Series Chassis Hardware Installation Guide 83
53-1001723-02
Troubleshooting network connections
3
Verify that the port has not been disabled through a configuration change. You can use the CLI.
If you have configured an IP address on the device, you also can use the Web Management
Interface or IronView Network Manager.
Verify that you have used the correct cable type for the connection:
For twisted-pair connections to an end node, use straight-through cabling.
For fiber-optic connections, verify that the transmit port on the device is connected to the
receive port on the connected device, and that the receive port on device is connected to
the transmit port on the connected device.
For copper ports, you can test the cable using Virtual Cable Testing. For more information, refer
to the chapter Monitoring Hardware Components in the FastIron Configuration Guide.
If the other procedures do not resolve the problem, try using a different port or a different
cable.
Support for digital optical monitoring
You can configure your Brocade device to monitor optical transceivers in the system, either globally
or by specified port or ports. When this feature is enabled, the system will monitor the temperature
and signal power levels for the optical transceivers in the specified port or ports. Console
messages and syslog messages are sent when optical operating conditions fall below or rise above
the XFP or SFP manufacturer’s recommended thresholds. For details about this feature and how to
configure it, refer to the FastIron Configuration Guide.

Table of Contents

Other manuals for Brocade Communications Systems FastIron X Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Brocade Communications Systems FastIron X Series and is the answer not in the manual?

Brocade Communications Systems FastIron X Series Specifications

General IconGeneral
BrandBrocade Communications Systems
ModelFastIron X Series
CategorySwitch
LanguageEnglish

Related product manuals