Brocade Communications Systems FastIron X Series Hardware Installation Guide

Brocade FastIron X Series Chassis Hardware Installation Guide 67
53-1001723-02
Verifying proper operation
2
The following shows the output of the show module command when entered on the FSX 800. The
display output is similar on the FSX 1600.
Syntax: show module
The Status column shows the module status. The status can be one of the following:
• OK – The module is up and running
• ACTIVE – This applies to the FSX 800 and FSX 1600 management and switch fabric modules
only. This indicates that the module is the active module as opposed to the standby module.
• STANDBY – This applies to the FSX 800 and FSX 1600 management and switch fabric
modules only. This indicates that the module is the standby module as opposed to the active
module.
• FAILED – The management module was unable to bring up an interface module properly. If you
observe this status, make certain that the interface module is installed properly. For more
information, refer to “Installing the management and interface modules” on page 51.
• DISABLED – The module is not up and running.
FastIron SX 800 Switch# show module
Module Status Ports Starting MAC
F1: SX-FISF Switch Fabric active
F2: SX-FISF Switch Fabric active
S1: SX-F424C 24-port Gig Copper OK 24 00e0.beef.0000
S2: SX-F424C 24-port Gig Copper OK 24 00e0.beef.0000
S3: SX-F42XGW 2-port 10G LAN/WAN OK 2 00e0.beef.0030
S4: SX-F424C 24-port Gig Copper OK 24 00e0.beef.0048
S5: SX-F42XGW 2-port 10G LAN/WAN OK 2 00e0.beef.0060
S6: SX-F424C 24-port Gig Copper OK 24 00e0.beef.0078
S7: SX-F424C 24-port Gig Copper OK 24 00e0.beef.0090
S8: SX-F424F 24-port Gig Fiber OK 24 00e0.beef.00a8
S9: SX-FIZMR4 0-port Management Active 0
{ Status : OK }
S10: SX-FIZMR4 0-port Management Standby 0
{ Status : Absent }

Brocade Communications Systems FastIron X Series Specifications

General

Brand	Brocade Communications Systems
Model	FastIron X Series
Category	Switch
Language	English