6.18 Set setpoint at alarm
You can program an automatic setpoint which will be
activated when an alarm situation occurs.
To change this alarm setpoint use button to select the
setpoint change option and press to enter the alarm
setpoint settings screen.
When entering the alarm setpoint settings screen the
setpoint change parameter is selected. Press to enter
the edit mode.
In the edit mode, use and to select ‘yes’ or ‘no’.
Press to exit the edit mode without changes.
Press to confirm your selection and to exit the edit
mode.
In the alarm setpoint settings screen press to select the
setpoint parameter. Press to enter the edit mode.
In the edit mode, use and to change each
character. Press to select the next character.
Press to exit the edit mode without changes.
To Next Page
Loading...
