4-7
Confidential
1.7 Acquiring White Level Data (Function Code: 55)
Acquire white level data as described in “1.3.18 Acquire white level data and set CIS scan
area (function code: 55)” in Chapter 5.
1.8 Adjusting Left-end and Upper-end Print Position
(Function Code: 45) (TT only)
Follow the instruction in “1.3.13 Change USB No. return value / Adjust left-end print
position / Adjust upper-end print position / Set HEXDUMP Mode (function code: 45)” in
Chapter 5
to adjust left-end or upper-end print position.
1.9 Resetting to Factory Shipping State
<Operating Procedure>
(1) Check that the machine is in the initial state of maintenance mode.
(2) Connect the computer to the machine with the USB cable.
(3) Check that the "Brother Maintenance USB Printer" is set as a default printer. If not, set it
as a default printer.
(4) Double-click the ShippingTool.exe file. The machine is reset to a factory shipping state.
(5) Unplug the AC cord of the machine.
Memo:
• Be sure to perform the procedure. Otherwise security level (e.g., against information
leakage risk) would be low.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
