282
Troubleshooting
(16) Tighten the nut firmly until it stops so that each tube is fixed to the print head.
M
C
Y
K
M4
C3
Y2
Bk1
X0406
(17) Close the front cover, turn on the power.
(18)
From the menu, select [Maintenance] > [Install Ink after Replacing Head] > [Color], and press
.
Perform the work operation by following the on-screen instructions.
<TIPS>
After the procedures are completed, the current screen will go back to the standby mode screen.
(19) Adjust the carriage speed.☞ "7-4-1. CR (Carriage) speed adjustment >>P.216"
(20) Print the nozzle check patterns. ☞ "7-2-1. Print out of the nozzle check pattern (checking on the print heads)
>>P.199"
(21) Perform the initial settings after head replacement configuration.☞ "7-4-2. Initial settings after head replacement
>>P.217".
(22) Adjust the ejection timing of print head.☞ "7-4-3. Firing adjustment >>P.218".
(23) Perform the platen feed adjustment.☞ "7-4-4. Platen-rolling adjustment >>P.219"
(24) Make the position adjustment between the white head and the color head.☞ "7-4-5. White/color alignment
>>P.261
Tube
Nut
Print head
*Remove the ink clot.。
To Next Page
Loading...
