Brother GTX pro - Page 312

312
Error message
Error code Error message Description Remedy Reference
1061 [Temp High]
The ambient
temperature rises
above the scope
covered by its
warranty for the best
print result.
Lower your room temperature.
"11-1. Apparatus >>P.350"
1064 [Humidity too Low]
The humidity
decreases below the
scope covered by its
warranty for the best
print result.
Raise your room humidity.
"11-1. Apparatus >>P.350"
1065 [Humidity too High]
The humidity level is
higher than the scope
covered by its
warranty for the best
print result.
Lower your room humidity.
"11-1. Apparatus >>P.350"
1070
[Battery To Be
Replaced]
Battery needs to be
replaced.
Make note of their error code and
error message, and please notify
it to your dealer.
-
1080 [RTC Not Adjusted]
The built-in clock has
not been set up.
Make note of their error code and
error message, and please notify
it to your dealer.
-
1085 [RTC Not Adjusted]
The built-in clock has
not been set up.
Make note of their error code and
error message, and please notify
it to your dealer.
-
1090 [Cap/Wiper Cleaning]
Cap and wiper need
to be cleaned.
Clean the cap and wiper.
"7-1-3. Cleaning the
nozzle guard, wiper,
exhaust cap, and suction
cap >>P.174"
1091 [Cap/Wiper Cleaning]
Cap and wiper need
to be cleaned.
Clean the cap and wiper.
"7-1-3. Cleaning the
nozzle guard, wiper,
exhaust cap, and suction
cap >>P.174"
1092
[Wiper Cleaner
Replacing White]
The wiper cleaner on
the white side needs
to be replaced with a
new one.
Replace the wiper cleaner with a
new one.
"7-1-4. Replacing the
wiper cleaner >>P.186"
1093
[Wiper Cleaner
Replacing White]
The wiper cleaner on
the white side needs
to be replaced with a
new one.
Replace the wiper cleaner with a
new one.
"7-1-4. Replacing the
wiper cleaner >>P.186"