Wireless configuration for Macintosh using the Brother installer application (MFC-9320CW only)
50
5
n Check the printed Network Configuration page. Choose the status as it is shown in the
Wireless Link Status on the Network Configuration page. Click Next.
If your status is "Link OK.", go to step p.
If your status is "Failed To Associate", go to step o.
o Click Finish. Wireless setup was unable to associate with a wireless network. This is probably due to
incorrect security settings. Reset the print server back to its factory default settings. (See Restoring the
network settings to factory default on page 79.) Confirm the security settings of your wireless network
and try starting from step e again.
To Next Page
Loading...
Need help?
General
