Brother MFC-9125CN - Page 332

5-105
Confidential
(7) Remove the TC arm spring from the Top cover arm R.
Fig. 5-113
Fig. 5-114
Assembling Note:
The assembling direction of the TC arm spring is fixed.
Make sure to assemble the TC arm spring in the direction shown in the figure below.
- Make sure to assemble the TC arm spring in a way that the end of the spring hook on the
joint cover sub ASSY side comes to the bottom.
- Make sure to assemble the spring hook of the TC arm spring in a way that the end with a
fold comes to the top cover arm side and the end without a fold comes to the joint cover
sub ASSY side.
Top cover arm R
TC arm spring
<Right side>
Hook
Hook
Joint cover sub ASSY
TC arm spring
End of the spring hook
Joint cover sub ASSY side
Top cover arm side