Brother MFC-9125CN - Page 578

App.1-45
Confidential
■ WSW55 (Interval of time requred for the developing bias voltage correction )
The setting example of the selector number is as follows;
■ WSW56 (Function setting 21)
- Selector 6: Switching of the display for the coverage of toner cartridge
This selector specifies the display for the coverage of toner cartridge. Setting this selector to “0”, the
machine displays the coverage only for the current toner cartridge. If this selector sets to “1”, the
machine displays the coverage for all toner cartridge which had been consumed.
- Selector 8: Switching of the CPU sleep mode
This selector specifies the CPU sleep mode ON or OFF.
Selector No. Function Setting and Specifications
1
l
8
Interval of time required for the
developing bias voltage correction
(hour)
0:
1-72:
73-254:
255 (0xFF):
The developing bias voltage
correction is performed on
each print job.
The developing bias voltage
correction is performed
when a print job occurs at
specified time or later.
Not allowed to set.
The developing bias voltage
correction is not performed.
No.1 2 3 4 5 6 7 8
0 0 0 0 0 0 0 0 : The developing bias voltage correction is performed on each print job.
0 0 0 1 1 0 0 0 : The developing bias voltage correction is performed when a print job occurs
after 24 hours or later.
0 0 0 1 0 0 1 0 : The developing bias voltage correction is performed when a print job occurs
after 72 hours or later.
1 1 1 1 1 1 1 1 : The developing bias voltage correction is not performed.
Selector No. Function Setting and Specifications
1
PS emulation function setting
(Not used.)
2
Switching of the PPT setting
(Not used.)
3
“Last Job Reprint” function setting
(Not used.)
4 Wireless LAN function (Not used.)
5
Switching of the echo suppression
improvement during calling (Not used.)
6
Switching of the display for the
coverage of toner cartridge
0: The coverage only for the current
toner cartridge
1: The coverage for all toner cartridges
which had been consumed
7
PCL emulation function setting
(Not used.)
8 Switching of the CPU sleep mode
0: Invalid
1: Valid (default)