Brother MFC-J460DW

Home > Security > Lock the Machine Settings > About Using TX Lock > Turn TX Lock On/Off
Turn TX Lock On/Off
Related Models: MFC-J460DW/MFC-J480DW/MFC-J485DW/MFC-J680DW
>> MFC-J460DW/MFC-J480DW/MFC-J485DW
>> MFC-J680DW
MFC-J460DW/MFC-J480DW/MFC-J485DW
1. Press Settings.
2. Press a or b to select the following:
a. Select [Fax]. Press OK.
b. Select [Miscellaneous]. Press OK.
c. Select [TX Lock]. Press OK.
d. Select [Set TX Lock]. Press OK.
3. Enter the registered four-digit password. Press OK.
The machine goes offline and the LCD displays [TX Lock Mode].
Turning off TX Lock:
a. Press Settings.
b. Enter the current four-digit password, and then press OK.
If you enter the wrong password, the LCD displays [Wrong Password] and stays offline. The
machine will stay in TX Lock Mode until the correct password is entered.
MFC-J680DW
1. Press
[Settings] > [All Settings] > [Fax] > [Miscellaneous] > [TX Lock] > [Set TX
Lock].
2. Enter the registered four-digit password using the Touchscreen. Press [OK].
The machine goes offline and the Touchscreen displays [TX Lock].
Turning off TX Lock:
a. Press [Unlock].
b. Enter the current four-digit password, and then press [OK].
If you enter the wrong password, the Touchscreen displays [Wrong Password] and stays offline. The
machine will stay in TX Lock Mode until the correct password is entered.
Related Information
• About Using TX Lock
423