Brother MFC-J460DW

Home > Paper Handling > Load Paper > Paper Settings > Change the Check Paper Size Setting
Change the Check Paper Size Setting
If the Check Paper setting is set to [On] and you pull the paper tray out of the machine, the LCD displays a
message asking if you want to change the Paper Size and Paper Type settings.
The default setting is [On].
>> MFC-J460DW/MFC-J480DW/MFC-J485DW
>> MFC-J680DW/MFC-J880DW/MFC-J885DW
MFC-J460DW/MFC-J480DW/MFC-J485DW
1. Press Settings.
2. Press a or b to select the following:
a. Select [General Setup]. Press OK.
b. Select [Check Paper]. Press OK.
c. Select [On] or [Off]. Press OK.
3. Press Stop/Exit.
MFC-J680DW/MFC-J880DW/MFC-J885DW
1. Press [Settings] > [All Settings] > [General Setup] > [Check Paper].
2. Press [On] or [Off].
3. Press .
Related Information
• Paper Settings
• Load Cut-Sheet Paper or Photo 2L Paper in the Paper Tray
• Load Photo Paper in the Paper Tray
• Load Envelopes in the Paper Tray
• Error and Maintenance Messages
54