BRP ROTAX 912 Series - Oil Change

BRP-Rotax
MAINTENANCE MANUAL LINE
OIL CHANGE
Instruction
NOTE
Run engine to warm oil before beginning oil change procedure. To change the oil
the following steps are necessary:
Step
Procedure
1
Crank engine slowly by hand to transfer the oil from the crankcase.
See Chapter 12-10-00 section Oil level check/Replenish.
2 Remove safety wire and oil drain screw from the oil tank, drain the used oil
- see environment note.
3
Replace oil filter at each oil change and inspect the filter matt.
See Chapter 12-20-00 section Oil filter replacement and Inspection of the
filter insert.
4
Dispose of oil filter according to environmental regulations.
5
Install oil drain screw with new gasket and safety wire (tightening torque 25
Nm (18 ft. lb).
Step
Procedure
1
Crank engine slowly by hand to transfer the oil from the crankcase.
See Chapter 12-10-00 section Oil level check/Replenish.
2 Remove safety wire and oil drain screw from the oil tank, drain the used oil -
see environment note.
3
Replace oil filter at each oil change and inspect the filter matt.
See Chapter 12-20-00 section Oil filter replacement and Inspection of the
filter insert.
4
Dispose of oil filter according to environmental regulations.
5
Install oil drain screw with new gasket and safety wire (tightening torque 25
Nm (18 ft. lb).
12–20–00
Page 42
January 01 2020
Effectivity: 912 Series
Rev. 0