BRUEL & KJAER PULSE 3560-C - Connecting Type 7533; Network Connection Using 10 Base 2

137
Appendix A
Connecting Type 7533
A.1 Network Connection using 10 base 2
LAN Interface Module Type 7533 is equipped with a BNC connector for 10 base 2. When
connecting the Type 3560-C front-end using this BNC connector, be aware that a cable
termination must be used. The ends of the cable must be terminated with a 50 Ω terminator.
Fig.A.1 shows how to use this configuration. 50 Ω terminators, T-connectors and RG 58
cables are all available from Brüel & Kjær.
Fig.A.1
10 base 2 setup
020235/1
RG 58 CableT Connector
50 Ω
Terminator
T Connector
50 Ω
Terminator
Notebook PC
Battery
status
On/Off
Follow/Ext. power
Battery
status
Ext. Power
10-32V
!
Ext.
Int.
Clock In
Aux.
I/O
Sync. In
Clock Out
Sync. Out
Rx
Tx
LAN
RS-232
LAN Interface Module
Type 7533
!
Input 0
Error
Clock
Sync.
Power on/off Control
On
Off
10Mbit
10Mbit
Brüel
Brüel
B
K
7/6-'89
7/6-'89
&
Kjær
Kjær
6/1-ch.
Input/Output Module
Type 3032A
Measuring Output
25kHz
Brüel
B
K
7/6-'89
&Kjær
Input
1
2
Tacho
Input
3
4
Input
5
6
Frontend