113
Chapter 11
Specifications
Compliance with Standards
(For environmental specifications and compliance with standards for PCs, see the specifications given by their
respective manufacturers)
Valid for Types 3560-B-010, -020, -030, -040, -110, -120, -130, -140, Types 3560-C, 3560-D and 3560-E with
Controller Module Type 7536, Input/Output Controller Module Type 7537, 7537-A, 7538, 7538-A, 7539, 7539-A,
7540 or 7540-A Input/Output Module Type 3035, 3038, 3038-B, 3039, 3039-B, 3040, 3040-B, 3041, 3041-B,
3109 or 3110
,
CE-mark indicates compliance with: EMC Directive and Low Voltage Directive.
C-Tick mark indicates compliance with the EMC requirements of Australia and New Zealand.
Safety EN/IEC 61010–1: Safety requirements for electrical equipment for measurement, control and
laboratory use.
UL 61010B–1: Standard for Safety – Electrical measuring and test equipment.
EMC Emission EN/IEC 61000–6–3: Generic emission standard for residential, commercial and light
industrial environments.
EN/IEC 61000–6–4: Generic emission standard for industrial environments.
CISPR 22: Radio disturbance characteristics of information technology equipment. Class B
Limits.
FCC Rules, Part 15: Complies with the limits for a Class B digital device.
EMC Immunity EN/IEC61000–6–1: Generic standards – Immunity for residential, commercial and light
industrial environments.
EN/IEC 61000–6–2: Generic standards – Immunity for industrial environments.
EN/IEC 61326: Electrical equipment for measurement, control and laboratory use – EMC
requirements.
Note: The above is only guaranteed using accessories listed in this System Data.
Temperature IEC 60068−2−1 & IEC 60068−2−2: Environmental Testing. Cold and Dry Heat.
Operating Temperature: −10 to +50°C (14 to 122°F)
Storage Temperature: −25 to +70°C (−13 to 158°F)
Humidity IEC 60068−2−78: Damp Heat: 93% RH (non-condensing at 40°C (104°F))
To Next Page
Loading...
Need help?
General
