PULSE Multi-analyzer System Type 3560-B/C/D/E – Installation and IDAe Hardware86
Each input has one BNT connector (see Fig.7.3 on page 89) and one 7-pin LEMO connector
(see Fig.7.6) for input of signals up to a frequency of 204.8 kHz. The BNT connector can be
used for direct connection of a voltage signal or connection of CCLD transducers and to
provide power for a tacho probe. The 7-pin LEMO can be used for connection of micro-
phone preamplifiers.
To Next Page
Loading...
